Description
Phoenix Contact TRIO-UPS-2G/1AC/24DC/5 Uninterruptible Power Supply
TRIO UPS - UPS with integrated power supply, USB (Modbus/RTU), DIN rail mounting, Push-in connection, input: 1-phase, output: 24 V DC / 5 A
Supply DC loads reliably and save space with the TRIO uninterruptible power supplies. An input grid is no longer necessary for startup. Connected industrial PCs can be shut down easily via the integrated USB interface.
| Input Data | |
| Input voltage range | 100 V AC ... 240 V AC -15 % ... +10 % |
| Voltage type of supply voltage | AC |
| Inrush current | < 16 A |
| Inrush current integral (I2t) | < 0.43 A2s |
| Frequency range (fN) | 50 Hz ... 60 Hz (±10 %) |
| Mains buffering time | ≥ 15 ms (120 V AC) |
| Switch-on time | typ. 60 ms |
| Typical current consumption | 3.3 A (100 V AC) |
| Input fuse | 6.3 A (slow-blow, internal) |
| Signal Bat.-Start | |
| Connection labeling | 3.6 |
| Signalization designation | Bat.-Start |
| Low signal | Connection to SGnd with < 2.7 kΩ |
| High signal | Open (> 200 kΩ between Bat.-Start and SGnd) |
| Signal Remote | |
| Connection labeling | 3.5 |
| Signalization designation | Remote |
| Low signal | Connection to SGnd with < 2.7 kΩ |
| High signal | Open (> 35 kΩ between Remote and SGnd) |
| Output Data | ||||||
| Efficiency | typ. 85 % (120 V AC) | |||||
| typ. 87 % (230 V AC) | ||||||
| typ. 96 % (Battery operation) | ||||||
| Derating | > 60 °C (2.5%/K of POut nom.) | |||||
| Crest factor | 2.7 (120 V AC) | |||||
| 3.2 (230 V AC) | ||||||
| Switch-over time | < 75 ms | |||||
| UPS connection in parallel | yes, with diode module uncoupled | |||||
| UPS connection in series | no | |||||
| Energy storage device connection in parallel | yes | |||||
| Feedback voltage resistance | ≤ 35 V DC | |||||
| Protection against overvoltage at the output (OVP) | < 30 V DC | |||||
| Residual ripple | < 20 mV | |||||
| Control deviation | < 0.75 % (change in load, static 10 % ... 90 %) | |||||
| < 1.25 % (Dynamic load change 10 % ... 90 %, 10 Hz) | ||||||
| < 0.1 % (change in input voltage ±10 %) | ||||||
| Rise time | < 15 ms | |||||
| Permissible backup fuse | B10 | |||||
| Mains operation | ||||||
| Output voltage | 24 V DC | |||||
| Output voltage range | 24 V DC ... 28 V DC (> 24 V constant capacity) | |||||
| Output current IN | 5 A | |||||
| Dynamic BOOST (IDyn.Boost) | 7.5 A | |||||
| Output power POUT (UN, IOUT = IN) | 120 W | |||||
| Maximum no-load power dissipation | < 3 W (230 V AC) | |||||
| Power loss nominal load max. | < 19 W (230 V AC) | |||||
| Battery operation | ||||||
| Output voltage | UBAT -0.1 V DC | |||||
| Output voltage range | 18 V DC ... 30 V DC | |||||
| Output current IN | 5 A | |||||
| Dynamic BOOST (IDyn.Boost) | 7.5 A | |||||
| Signal Alarm | ||||||
| Connection labeling | 3.2 | |||||
| Signalization designation | Alarm | |||||
| Type of signaling | LED red | |||||
| Switching output | Transistor output, active | |||||
View AllClose
Additional Information
Related ProductsRelated Products
Out of stock
 Phoenix Contact QUINT4-UPS/24DC/24DC/10 Uninterruptible Power SupplyPhoenix Contact
$448.99
Phoenix Contact QUINT4-UPS/24DC/24DC/10 Uninterruptible Power Supply
Out of stock
Phoenix Contact UPS-BAT/PB/24DC/4AH Battery Module for Use with UPS SystemsPhoenix Contact
$255.00
Phoenix Contact UPS-BAT/PB/24DC/4AH Battery Module for Use with UPS SystemsBattery module (device with battery), VRLA-AGM, 24 V DC, 4 Ah, automatic detection and communication with QUINT UPS-IQ
Out of stock
Phoenix Contact UPS-BAT/PB/24DC/1.2AH Battery Module for Use with UPS SystemsPhoenix Contact
$169.00
Phoenix Contact UPS-BAT/PB/24DC/1.2AH Battery Module for Use with UPS Systems
Out of stock
Phoenix Contact RIF-0-RPT-24DC/21 Relay ModulePhoenix Contact
$15.00
Phoenix Contact RIF-0-RPT-24DC/21 Relay Module
Out of stock
Phoenix Contact 3032237 Plug-in Bridge Pitch 6.2 mm GrayPhoenix Contact
$1.99
Phoenix Contact 3032237 Plug-in Bridge Pitch 6.2 mm Gray
| ||||||